TX-4030 Rigger Truck

Wide stance for more stable and confident handling Carriage Groups 96-in “C” type standard Simple design- • bolt-on housing • Timken tapered roller bearings • cast nylon side thrust pads • shims, if necessary Minimal maintenance with more resistant to dynamic/shock loads with rough terrain, high lift, and/or offset loads 36-in. Load Center rigger Lift with Confidence The pin-mounted forks are hammer forged from heat treated steel with increased thickness in critical heel sections. The forks are fully adjustable from full width of carriage to +/-2-in. Lengths and widths vary depending on your particular needs and model type. The mast and carriage main rollers are common and use Timken® tapered roller bearings. Chain rollers use sealed ball bearings. Common, cast nylon, side thrust pads are adjustable to compensate for wear. Rigger Application: [if traveling less than 1 mph up to 48-in. lift.] TX-4030 (40,000-lb. Cap. at 36" L.C., 132" WB) TX-4030 (30,000-lb. Cap. at 36" L.C., 132" WB) The TX Series features the most dependable and diverse assortment of mast and carriages in its class. Known for their innovative design, these masts give you the confidence in knowing it will work every time you need it. Even when maintenance is required you can feel safe knowing our engineers have designed our mast and carriages to be as easy to maintain and repair as possible. The 150.5-in. telescopic three-stage mast, has nested channels and is constructed of high strength steel. The 3-stage, 8-in. telescopic lift cylinder is a direct lift design and has 38-in. of Free Lift. Two lifting eyes and bolt-on caps permit safe, easy removal of the mast in the event that repair is needed.